CareerPlan

Design Release Engineer Brackets and Accessory System

Auburn Hills, MIFull-time2026-11-16
On-site

Core

Develop engine brackets and front-end accessory drive (FEAD) systems, integrating structural mounting, belt-drive performance, and powertrain packaging for production release.

Role type

Senior IC mechanical design release engineer (automotive powertrain)

Builds

Engine brackets, cast/forged/stamped/welded components, and FEAD architectures (belt routing, pulleys, tensioners, decouplers)

Domain

Automotive powertrain and mechanical design

Required skills

bracket load definition, static and fatigue analysis, modal behavior, vibration durability, joints, fasteners, bolt preload, casting, forging, stamping, weldment design, corrosion, thermal expansion, powertrain motion envelopes, assembly and tool access, tolerance stack-up, FEAD architecture, belt-drive design, pulley and routing optimization, tensioner and decoupler selection, accessory loads, crankshaft torsional interaction, belt slip and durability, alignment, noise, vibration and harshness (NVH), chirp and squeal, thermal and contamination effects, packaging, serviceability, CAE and vehicle validation

Preferred skills

DFMEA, DVP&R, APQP, PPAP, supplier management, 8D, 5-Why, fault-tree, fishbone analysis

Technologies

PLM, BOM, CAD-viewing, requirements, change-management, issue-tracking systems

Responsibilities

Develop bracket requirements and guide cast, forged, stamped, and welded designs; Develop FEAD architecture, belt routing, pulleys, tensioners, and decouplers; Coordinate structural, fatigue, modal, belt-durability, and vehicle validation; Guide CAD models and drawings; coordinate CAE, calculations, and test correlation; Lead DFMEA, DVP&R, and APQP activities; Resolve failures and engineering changes with suppliers and specialists

Seniority

Senior, hands-on IC